Lennox-international-inc WING Manuel d'utilisateur télécharger pdf (Page 27)

LTX 3

LTX 5

1.321 mm

562 mm

1.630 mm

670 mm

To remove the casing, slide them over the rolling

sides and remove horizontally (See picture A).

Remove the AIR VANES by moving them in the

opposite direction of the air sweep motor until

they come out, then release the central fixing

clip, so that the AIR SWEEP is removed giving

better access to the top of the unit (See picture

B).

Install the unit with the M-8 screws, always use

washers. Fix the screws following the pattern

on page 26.

Check the strength of the screws to avoid

movement of the indoor unit when removing the

side and cover panel.. See picture C

INSTALLATION UNIT

Install the unit in a way that the discharge air would not be direct to persons, differences of temperature can create

disturbs.

Keep in mind in the installation of the unit, some ambient can supply electromagnetic radiation that can affect the

good function of the unit, follow then the following instruction recommended in this document.

OPENING IN FLASE CEILING

Always install the filters. If the unit operates

without filters there is a risk of damage in the

indoor unit from dust..

Min. 100 mm.

AIR-SWEEP

Rolling sides

Filters

Sides and carcass

INSTALLATION INDOOR UNIT

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33 34

Pas de commentaire

Lennox-international-inc WING Manuel d'utilisateur Page 27